Tally T6215, Maintenance Manual

Page: 90 / 164

T6215 Maintenance Manual
4–20
Grease
Grease inside of
both frame end
plates
Grease
Grease
Grease
Figure 24. Adding grease.
Step 14. Grease the sideplates of the print mechanism where they will come in contact
with the Platen Gap Adjustment plates.
Step 15. Place the new platen into the print mechanism. The platen pins slide into the
slots on the sideframes. The Platen Gap Adjustment plates interface with two
5/16" standoffs mounted to the inside of the sideplates.
The hook in the Platen Gap Adjustment plate goes over the lower standoff and
the setscrew of the Platen Gap Adjustment plate contacts the upper standoff.
Keep the long axis of the platen perpendicular to the sideplates to prevent
wedging of the platen.
Step 16. Move the platen stop back in contact with the sideplate, so that its tab is
located under the lower right edge of the platen. Place the washers over the
posts in the sideplates and reattach the three screws.
Step 17. Reattach the springs, being careful they do not come loose and snap toward
you.