Tally T2265plus, User Manual

Page: 61 / 196

User guide 2T model
51
2T model
Introduction
This section describes how to handle the rear tractor (paper feed
from the rear), which is only available and permanently installed in
the 2T printer model in addition to the primary tractor (paper feed
from the front).
The Paperway parameter group in the menu of the 2T model differs
from the one of the standard printer as follows:
* Not installed on some models.
The permanently installed rear tractor is identified as “Trac3”
in the menu. “Trac2“ in the menu refers to the optional tractor
which can be installed both on the standard printer and the 2T
model. The optional tractor 2 can be installed by the user.
Rear tractor paper path
For information on the printable length and width of the forms
and other specifications, refer to
Paper specifications , page 136.
The 2T model cannot accommodate an additional automatic
single sheet feeder.
8
Standard printer 2T printer
Paperway
Single*
Tractor1 (standard, front)
Tractor2 (optional, front)
Paperway
Single*
Tractor1 (standard, front)
Tractor2 (optional, front)
Tractor3 (standard, rear)
Tractor 1
Tractor 2
Tractor 3