Tally Dascom DL-830, User Manual

Page: 88 / 91

Tally Dascom DL-830 User Guide V1.0
76
9.3 TSPL Command Set
Commands Description
SIZE This command defines the label width and length.
BLINE
This command sets the height of the black line and the user-defined
extra label feeding length each form feed takes.
BARCODE This command prints 1D barcodes.
QRCODE This command prints QR code.
GAP Defines the gap distance between two labels.
REFERENCE This command defines the reference point of the label.
SPEED This command defines the print speed.
DENSITY This command sets the printing darkness.
SET PEEL
This setting is used to enable/disable the self-peeling function. The
default setting for this function is off.
SET CUTTER
This setting activates or deactivates the cutter and defines how many
printed labels is to be cut at one time.
SET
PARTIAL_CUT
TER
This setting activates or deactivates the cutter and defines how many
printed labels is to be cut at one time.
SET TEAR
This command is used to enable/disable feeding of labels to gap/black
mark position for tearing off.
SET RIBBON This setting is used to enable/disable ribbon sensor detection.
DIRECTION This command defines the printout direction.
SHIFT This command moves the label’s vertical position.
OFFSET
This command defines the selective, extra label feeding length each
form feed takes, which, especially in peel-off mode and cutter mode, is
used to adjust label stop position, so as for label to register at proper
places for the intended purposes. The printer back tracks the extra
feeding length before the next run of printing.
BITMAP This command draws bitmap images.
REVERSE This command reverses a region in image buffer.
CLS This command clears the image buffer.
PRINT
This command prints the label format currently stored in the image
buffer.