TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
Page
37
of
59
11.2 Lubricating
Adequate and regular maintenance of the assemblies significantly helps to prevent
premature failure of parts protects against corrosion of the elements. The list of greasing
points given below describes the location of each of the greasing points and the type of the
grease required. It is recommended to use grease gun to apply solid grease. Clean the place
off old grease residues and contaminations before greasing. Check the condition of the
grease nipples; if any is damaged replace it with a new one. Keep slowly injecting grease
until all of the old grease has been purged from the grease nipple and the new grease starts
to ooze out. Wipe off the excess of grease to keep the dirt away. There is SAE90EP oil in the
oil reservoir of the rotor gearbox –do not use any other type of oil than recommended. The
nominal volume of the gearbox is 5.7-6l. The first change of oil should be done after first 50h
of work. The next oil change should be done after each 400h of work. It is recommended to
change oil in the gearbox at least once a year, before start of the season. Inspect the rotor
for oil leaks each time before starting work. Fix revealed leaks immediately and fill in the oil
in the reservoir to the required volume. Any repairs to the rotor gearbox during warranty
period can be done only by an authorised workshop.
Table 4
. Lubrication and service intervals
NO
Greasing points
Description
Service intervals
Type of
grease
1
Main pivot pin
socket
10h
Solid
grease
2
Roller bush of the
main pivot pin
10h
Solid
grease
3
Connection of the
steering rod with
the headstock
10h
Solid
grease
