Page
41
of
129
SELF-LOADING BALE WRAPPER
SPRINTER 1500
The operation of the bale tipper depends on the position of the adjustable arm (1). When the arm is in the
horizontal position, the bale will roll down behind the bale wrapper (Figure 24), while if the arm (1) is in
the vertical position (Figure 25), the bale will roll down to the side.
The procedure for switching over the bale unloading way:
1.
Lift the cradle frame.
2.
Remove the safety locking pin.
3.
Switch the adjustable arm.
4.
Mount the safety locking pin.
5.
Lower the cradle frame.
To change the position of the adjustable arm, the cradle frame needs to be lifted and the adjustment pin
removed
6.6.
Bale grab adjustment
Figure 26 Bale grab arm adjustment
(1) frame, (2) buffer, (3) adjustable arm, (4) lock screw, (5) buffer fixing
Customise the bale grab arm to the size of the baled crop. Setting the adjustable arm (3) ensures the
proper loading of the bales onto the table roller assembly. Depending on the length of the bales, set the
buffer (2) so that it is in the middle of the table roller assembly when the bale is loaded. The position of
the adjustable arm (3) depends on the diameter of the baled crop. Small diameter bales are loaded when
the arm is at its shorter setting, whereas larger bales – at its longer one. The adjustable arm (3) must be
locked with the screw (4) against being pulled out.
Summary of Contents for SPRINTER 1500
