Page
34
of
129
SELF-LOADING BALE WRAPPER
SPRINTER 1500
6.
Machine operation
The manufacturer shall ensure that the machine is fully operational and has been checked before
being put into service. Nevertheless, the user is obliged to check the machine after delivery and
before the first use. Before commencing any works related to coupling the bale wrapper with the
tractor, the user should check the technical condition of the machine and prepare it for
commissioning. In order to do so, the user should:
a)
read carefully all the information related to the safety, design, functioning, operation,
transport, technical service, etc. included in the manual,
b)
familiarise themselves with the design and operating principle,
c)
check the completeness of the machine, whether all require protections, screws are in place,
d)
check the condition of screw connections, whether all screws are tightened – Table,
e)
check the condition and pressure of tyres,
f)
check the appropriateness of wheel mounting,
g)
check the painting coating condition,
h)
check the overall condition of the machine with regard to any damage caused during
transport, loading or due to other circumstances (breakage, indentations, cracks, punctures,
etc.),
i)
check all lubrication points, whether there are lubrication signs (if needed, lubricate acc. to the
guidelines in Section “ Machine lubrication“),
j)
check that the drawbar, bale grab arm and bale tipper are attached correctly,
k)
check that the film dispenser post is fixed properly,
l)
check the hydraulic system for tightness,
m)
check the proper operation of the lighting system,
n)
check the proper operation of the protection sensors.
After performing all activities and stating that the machine condition raises no concerns, the user
may couple the bale wrapper with the tractor.
Before every time the machine is used, its technical condition needs to be checked, and especially the
condition of units like rotation transmission system, hydraulic and electrical systems.
Summary of Contents for SPRINTER 1500
