Talex LEOPARD RB 160, Instruction Manual

Page: 6 / 40

TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail. biuro@talex-sj.pl
www.talex-sj.pl
6

The grinder shall be adjusted for the operation while the assembly. The position can be adjusted
from the operator’s cabin, with no need to leave a cabin.

All action connected with the preparation, assembly, disassembly or adjustment can be made
only upon the driver shut-off, engine stop, stoppage of a vehicle and waiting until all movable
elements of the machine shall be in a standstill.

The condition of all temporary Hastings, screw connections shall be checked upon first hour of
operation.

The grinder shall be stored on a flat, leveled and hardened surface that is unavailable for
outsiders and animals. A supporting flange shall be applied for stable position of a grinder.

Special care shall be kept while assembly and disassembly of a grinder paying special attention
to construction elements responsible for attaching behind a vehicle.

The technical condition of a grinder and attached vehicle shall be verified prior to the operation.
The unit, vehicle and grinder shall be maintained in a good technical condition. Worn and
damaged parts shall be replaced immediately.

The grinder shall be equipped with all protective covers (recommended by a manufacturer)
against movable parts. The covers shall be complete and in good condition.

It is necessary to read the manual, occupational safety regulations and recommendations on the
servicing and adjustment prior to the operation.

The grinder’s weight mounted on a vehicle can influence on the maneuverability.
Special care shall be kept in this case.

The manual shall be kept with the machine. If the machine is lent it shall be in a good technical
condition and with the manual.

Attaching additional transport means to the grinder is forbidden.

Check the machine operations and initial adjustment with no duty shall be made while the start-
up.

Assembly protection TUZ (three point suspension system) of a grinder bolts shall be done only
with typical protections such as pins. Operation with other protection type is forbidden.

Because of natural wear it is necessary to control the condition and completeness of cutting
tools of the machine by observing recommendations described in a chapter „6. Service and
maintenance activities”.

The technical condition of the machine shall be checked while the reception and transport of the
grinder.