TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
19
Table No. 2
MAXIMAL CLEARANCES OF GRANULATING TOOLS
Clearance
nominal
[mm]
allowed
[mm]
Knife
Beater
Knife
Beater
Axis
transverse
0,2
0,3
0,5
0,6
Axis
transverse
0,1
0,2
0,4
0,6
Granulating tools shall be replaced keeping in mind special safety regulations.
1.
Only original and operable cutting parts shall be used
2.
The replacement covers the whole set of tools. It shall be remembered that the distribution of
vibrating weight must be even and wear of tools shall be regular as well.
3.
Screw connections shall be replaced each time with tools keeping in mind that the class of screw
resistance and locknut is 10.9.
4.
While screw tightening it is necessary to pay attention to loose of cutting tool turn but with no
excessive loose (beater or knife set) with regard to screw axis.
6.3 After operation service
The machine shall be cleaned and positioned on a even and hard surface after operation. The inspection
of parts and elements connections shall be done. Damaged and worn parts shall be replaced. Check all
screw connections and tighten loose connections according to table no. 3 – tightening torque value for
screws and nuts.
Table no. 3
TIGHTENING TORQUE VALUE FOR SCREWS AND NUTS
Strenght
6.8
8.8
10.9
12.9
Metric thread
Torque [Nm]
M5
4,5
5,9
8,7
10
M6
7,6
10
15
18
M8
18
25
36
43
M10
37
49
72
84
M12
64
85
125
145
M14
100
135
200
235
M16
160
210
310
365
M18
220
300
430
500
M20
310
425
610
710
M22
425
580
820
960
M24
535
730
1050
1220
All safety signs placed on the machine, triangle plate for low powered trucks shall be kept clean.
