11
Nozzle Arch Setup
１
Remove the drain cap from the drainage
outlet in the basin
The drain cap should be placed outside the
basin.
２
Attach the nozzle arch
Insert the base rubber of the nozzle arch to
the drainage outlet in the basin.
CAUTION
・
Be sure to keep the customer’s
hair from being caught.
・
Avoid contact of the nozzle
arch with the customer.
・
Do not hold the nozzle cover
because this may lead to
damage.
Drain cap
Drainage
outlet
Nozzle arch
Base rubber
Check that the
nozzle arch is tilted
towards the front.
３
Hold the shower head with a rubber band
(i) Switch the shower head to shower mode.
The amount of hot water output in
low-splash foaming mode is not sufficient
for cascades of water, and the head bath
sensation may not be obtained.
(ii) Insert the shower head into the rubber
holder while holding the rubber band
towards the customer side.
(iii) Return the rubber band to hold the
shower head.
Press the convex side of
the switch to change to
shower mode.
CAUTION
If the shower head is not secured
properly with the rubber band,
the shower head may become
displaced and cause hot water to
splash into the surrounding
area.
CAUTION
When inserting the shower head
into the holder, pull the shower
head straight out before insert-
ing it into the holder. The shower
hose may break if it is bent
forcibly.
Nozzle cover
Rubber holder
Shower head
Rubber band
Rubber band
Front side
OASIS basin
OASIS basin
Backwash (YUME) basin /
Sidewash basin
Backwash (YUME) basin /
Sidewash basin
Summary of Contents for AY-YHBSS Series
Page 23: ...23 Notes...
