TAJIMA TFMX-IIC, User Manual

Page: 80 / 268

Check items before embroidering
66
Chapter 4
6-2. Embroidery head
Check the position of the following tension base switch, needle bar suspension lever, middle thread guide
adjusting lever before embroidery.
Regarding the tension base switch and the needle bar suspension lever, embroidering is possible only when
both of them are set to "ON".
(1) Tension base switch
This switch will suspend the head electrically.
The switch operation during working of the machine is invalid. Even if the switch operation is performed,
it will become effective after the machine stops.
Tension base switch
Green Red
Unlit Lit
OFF
Thread breakage indicator lamp
Lit in green Ready to embroider
Unlit Embroidery is suspended. (Needle bar will not move down.)
Blinking in
green
Frame back section at the head without thread breakage. The lamp at the
head without thread breakage blinks in green during Frame Back
Regarding Frame Back, refer to the detail page.( → p.69)
Lit in red Upper thread breakage
Blinking in red Under thread breakage