TAJIMA TEMX-C Series, User Manual

Page: 87 / 242

To trim thread
74
Chapter 5
QS07
2-2.
To trim thread automatically (ATH)
It is the setting to trim thread.
2-2-1.
Explanation on the screen
[a]
To trim thread automatically
YES: To trim
NO: Not to trim thread
[b]
Length of remaining upper thread after thread trimming (1 in the
right figure)
When upper thread remains on the fabric, select the value of "-".
If sewing is impossible due to short of remaining length of upper
thread, select the value of "+".
When "N" is displayed, the value differs in each needle bar.
Regarding the setting of needle bar unit, refer to the detailed page.(p.101)
[c]
Number of lowering the needle bar by slow operation at start after thread trimming or after data
set
F2
YES
9 ATH
YES/NO
N
-8
4
2
Return Stitches
NO
1/2/T0/T1/T2/NO
Return Stitch Length
N
A
A/B/C/D
Thread Trim Length
9
+8
Tie Stitches
Tie Stitch Length
N
0.6 2.0 [mm]
0.2 2.0 [mm]
[b]
F2
9 ATH
B
A/B Hook
Next page
[c]
[d]
[e]
[f]
[g]
[h]
[a]
To trim thread automatically
Remaining length of upper thread
Number of lowering needle bar at slow operation
Return Stitches
Return Stitch Length
Tie Stitches
Tie Stitch Length
Thread holder
Inching after ATH
1
-8 +8
Short Long
0