TAJIMA TCMX 601, User Manual

Page: 118 / 130

Maintenance
14-5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
5.
Inspection
6.
Repair
WARNING
When inspecting the machine, be sure to turn off the primary power supply (before turning off
the primary power supply, turn OFF the power switch). You could sustain severe injury due to
being entangled by the machine.
Inspection Point Contents of inspection Inspection Cycle
Attaching of each cover Attach all covers.
At start of working
Setting of embroidery thread Set the thread to the correct position.
Needle Check breakage or bending.
Lubrication to each spot Perform lubrication according to need.
Belt of main shaft drive system
Tension of belt, degree of wear, existence of crack
Once/3 months
Belts of X/Y drive system
Rotating and sliding part Degree of wear
WARNING
Before working, be sure to turn off the primary power supply (Before turning off the primary
power supply, turn off the power switch). Even if the primary power supply is turned off, some
circuits are still charged. Wait (4 minutes) until these circuits are completely discharged and
then start working.
If the machine needs repairs, the repairs must be done only by the service personnel assigned
and trained by Tajima or qualified technician. (Consult your distributor.)
Do not change the specification nor modify the parts of the machine without due consultation
with Tajima. Such modification may risk the operational safety.
When restarting the machine after repairs, attach all covers etc. which were removed for repair
operation.
CAUTION
For the machine repairs, use TAJIMA genuine parts for replacement.
!
!
!
!
!
!
!
!
JZ07