39
RC
Pin-out: II G V+ G L H.
II: PPM/SBUS G: GND V+: POWER(5V) G: GND L: CAN-bus-L
H: CAN-bus-H (CAN-bus is not supported yet).
The RC port can provide 5V power supply for S. BUS application.
7.
FAQ
Q1: How to install management software and driver, and how to use management software?
Please read Chapter 4 of this document.
Q2: How does the Taisync module supply power?
Air unit: DC, power supply range: 8-15V, recommended to use 12V, Taiysnc provides power
supply cables.
Ground unit: DC, power supply range: 8-15V, recommended to use 12V, Taiysnc provides
power supply cables.
Q3: Can the Taisync module be powered on before antennas installation?
The antennas must be installed before power on.
Q4: How many antennas do Taisync's air unit need to be installed?
Two antennas need to be installed.
Q5: How many antennas do Taisync's ground unit need to be installed?
Two antennas need to be installed.
Q6: Can different types of remote controllers be used to control drone?
Yes, just output standard PPM signals through the coach port, or use S. BUS receiver.
Q7: Video compression protocol supported by Taisync module?
H.264 & H.265.
Q8: Can two air units be installed on a drone?
No, a drone can only integrate one air unit.
Q9: Can two ground units be installed at the receiving end?
The ptp system can only install one ground unit; the ptmp system supports more than one
ground units.
