5
1.2 Installation
1.2.1 HDD Installation
HCS-8130M Series Recorder can installation of at most
four HDDs, one of them as main-HDD which includes a
conference data area and a recording storage area and
others as hypo-HDDs which only have a recording
storage area. HCS-8130M Serises Recorder is with a
1000G HDD (default as main-HDD) when leaving factory.
Based on the record schedule, you can calculate the
total capacity you need (refer to Appendix A) and add
other HDD. Please ask the specialist to disassembly the
recorder and install HDD.
Installing the harddisks must be performed by qualified
personnel. Unauthorized installation of harddisks may
result in permanent damage of the disk and the recorder,
and is performed at your own risk.
Procedure:
1. Before installation of the HDD, switch the recorder off
and unplug the power cable;
2. Place the recorder on a flat table, and make sure you
take proper ESD precautions. Wear an ESD bracelet
at all times. A Philips screwdriver is required to
disassemble and reassemble the unit;
3. Remove the metal top cover by removing screws;
4. Fix and fasten four attached posts to the bottom cover;
Figure 1.3
Installation of the posts
5. Place the metal harddisk bracket on top of the
harddisks, and fasten each harddisk with 4 screws to
the bracket;
Figure 1.4
Installation of the bracket onto the harddisk
6. Set the bracket to the fixed posts and fix the bracket
with 4 screws or 4 posts (if more HDD is needed);
7. Connect the power and data cables to the HDD and
main board;
Figure 1.5
Cable connection
8. Repeat above steps, up to 4 HDD can be installed
(two at the left and the other two at the right);
9. Check all connections, and reinstall the metal cover on
the recorder.
Caution:
)
When working with electrostatic sensitive
devices such as a hard disk or the recorder,
make sure you use a static-free workstation.
Any electrostatic energy coming in contact
with the hard disk or recorder main board
can damage it permanently.
