Taiden HCS-4800 Series, Installation And Operating Manual

Page: 163 / 233

3.12.4 Operation
Before a meeting starts, the congress units need to be
configured by the operator, including: numbering and
testing.
1. Numbering
First of all, make sure that the congress units are
connected properly to the CMU. All congress units
must be numbered when the system is used for the first
time or when adding or replacing congress units. The
numbering function can be activated by application
software or main unit.
The indicator of connected congress unit will flashing,
press
■ Press “Unit Numbering” on application software.
The system now goes to numbering status. At this
time, press the of each congress unit in one by
one. Once all congress terminals numbered,
restart the CMU to update the number information.
■ Rotate the function knob to select “0.5 Numbering”,
then select and press “start” .The LCD screen of
the main unit shows “Press key of DCS Units, one
by one and reboot EMU”; meanwhile, LCD screen
of those connected congress units will pop up a
number; press “numbering” key of congress units
one by one; reboot the main unit after all congress
units being numbered for updating .
2. Speaking (without software)
Speaking mode is configured on the CMU.
A. “Open” mode

Active microphone number limitation (1~8) NOT
reached :
c. The microphone will be activated when the
microphone On/Off key is pressed, the speaker
can give his/her speech;
d. The microphone will be deactivated when the
microphone On/Off key is pressed again.

Active microphone number limitation (1~8)
reached :
d. Press the microphone On/Off key to request to
speak;
e. Press the microphone On/Off key again to
cancel the request to speak;
f. When an active microphone is turned off, the
first request microphone will be activated.
B. “Override” mode
■ Active microphone number limitation (1~8)
NOT
reached :
c. The microphone will be activated when the
microphone On/Off key is pressed, the speaker
can give his/her speech;
d. The microphone will be deactivated when the
microphone On/Off key is pressed again.

Active microphone number limitation (1~8)
reached :
If the delegate microphone On/Off key is pressed,
its microphone will be activated and the first
activated delegate microphone will be deactivated
at the same time to maintain the active
microphone number limitation. If the number of
active microphone (including chairman and VIP
unit) reaches 8, turning on another microphone will
switch off the delegate microphone turned on first.
C. “Voice” mode

Active microphone number limitation (1~8) NOT
reached :
d. The microphone On/Off key indicating light
remains on. When the delegate speaks into the
microphone at a short distance, the microphone
will be activated;
e. If the delegate does not speak for several
seconds, the microphone will be deactivated
automatically. The interval time can be adjusted
at the main unit (refer to section 2.1.3);
f. When the microphone is activated, it can be
turned off by pressing the microphone On/Off
key.

Active microphone number limitation (1~8)
reached :
All other microphones cannot be activated unless
one of the active microphones is turned off.
Note:

Please number the congress units one by one
and do NOT press the button of several
congress units at the same time.
150