Taiden HCS-4800 Series, Installation And Operating Manual

Page: 144 / 233

3.9.3.3 HCS-4840DHT connected to the
HCS-4842DHT
The HCS-4842DHT channel selector is equipped with
a standard RJ45 socket. When connecting to the
HCS-4840DHT multi-function connector, just use Cat.5
cable with standard RJ45 plugs to connect the RJ45
socket of the congress unit into the corresponding
RJ45 socket of the multi-function connector (figure
3.13.18).
Figure 3.9.5 HCS-4840DHT multi-function connector
connected to HCS-4842DHT channel selector
3.9.3.4 External earphone
An external earphone can be connected to the
earphone jack of HCS-4842DHT channel selector. Its
volume can be adjusted by the earphone volume
control button. The external earphone shall have
Ø 3.5 mm plug, as the following figure:
Functions and indications:
1 Left stereo channel signal
2 Right stereo channel signal
3 Power ground/Shield
3.9.4 Operation
Before a meeting starts, the congress units need to be
configured by the operator. During the meeting, the
participators can use the congress unit to select SI
channel to listen.
1. Channel selection (only for units with simultaneous
interpretation)

When the CMU is connected to interpreter unit(s),
simultaneous interpretation function will work and
the channel selector will be activated. To use the
channel selector, an earphone must be plugged in.
When the earphone is plugged, the delegate can
select a suitable language to listen to by means of
the channel selector.
2. Volume control (only for units with simultaneous
interpretation)

When the earphone is plugged, its volume can be
adjusted by the earphone volume control of the
unit.
131