Tadpole VIPER, User Manual

Page: 58 / 210

Restarting VIPER
Restarting a VIPER that has been halted and powered
down is a simple procedure:
1. Verify that cables from all connected peripheral devices,
such as an external monitor, are connected to the appropriate
connectors on the back of the VIPER.
2. Power-up the peripherals before powering-up the
VIPER (see peripheral manuals for more information).
3. Turn on the VIPER.
The VIPER begins its self-test diagnostics and starts to
boot. It is normal for the screen to be blank for up to 20
seconds before displaying the following initial message:
VIPER (UltraSPARC-IIIi xxxMHz),
OpenBoot x.xx Tadpole x.xx, xxxx MB memory installed,
Serial #xxxxxxx
Ethernet address x:x:xx:x:x:xx, Host ID: xxxxxxxx
Various system messages will appear on the screen dur-
ing the boot process. After the last system message, the
screen will prompt you for your login name and then
your password.
4. Type your user ID at the user name prompt and click OK or
press Enter.
5. Type your user password at the password prompt and click OK
or press Enter.
Using VIPER
Operating VIPER
32 VIPER Product Family User’s Guide