SPARCbook Portable Workstation User Guide
10-5
PCMCIA Interface
Installing a PCMCIA Card
Installing a PCMCIA Card
Caution
You do not need to power your SPARCbook off before inserting or removing a single
PCMCIA card. However, to prevent data loss or corruption when inserting or
removing a second card, you must ensure that either your SPARCbook is powered
down or that there are no operations in progress with the card that is already
installed.
To install a PCMCIA card, proceed as follows:
1.
Open the PCMCIA port door. (You can remove the door if you
wish, as previously described.)
2.
Insert your PCMCIA card into the slot with the 68-pin connector
end in first, taking care to align it correctly in the card guides.
3.
Push on the PCMCIA card firmly, and it will click into position.
Figure 10-3 The PCMCIA Flap
S3UG4_Book Page 5 Friday, August 8, 1997 11:37 am