DR-500
Installation guide
1
Surface
Mount
Flush/Surface
Mount
General:
The 5 wires panel is an intercom system, serves as a door panel.
The main advantage of the system is that the panel doesn't require a
special design handset for the system and can work with any standard 5
wires handset.
With this unit you can speak with the visitor who is waiting at
the door and open the electric lock from the intercom handset .
An optional bypass pushbutton enables easy internal
opening (the opening time is programmable)
Features:
Easy installation, programming and
operating.
optional bypass exit pushbutton
Surface and flush mount installation available
Environmental and anti vandal resistance.
Specifications:
Operating voltage: AC 12V 800mA
Operating electric or magnetic lock. (normally
open)
Opening time: 1-9 seconds
Color: silver or bronze
Size: under plaster195X115X50mm (H*W*D)
On the wall 154X100X35mm (H*W*D)
Installing The DR-500 Panel:
Install the lock in the door frame.
Using a Phillips screwdriver open the top cover, carefully pull up the panel.
Using a screw driver, expose the 4 covered insulations bores and the round wirings bore.
Attach the base of the Intercom Encoder to the wall, using a pencil mark the 4 fixing points.
Drill the 4 fixing points on the wall.
Route the wires through the round bore in the base of the Intercom Encoder.
Using 4 screws install the base to the wall.
Handset wiring
Several common handsets could be assembled.
Electric buzzer handset can not be assembled, Only electromagnetic
Wiring of different handsets is detailed in the electrical drawing in page 4 and the following
table:
Amplyvox
handset
Audio
Interphone
Videx
handset
SMART 1P
URMET
Wire
0
6
3 / 7
6
COM
Z
9
5
9
lock
1
BZ
6
Second
buzzer
connection
buzzer
T
1
1
1
speaker
R
2
2
2
microphone
