Tadiran Telecom Coral IPx Office, Installation And Hardware Reference Manual, Page: 69 / 510

Coral IPx Office Installation Manual Hardware Installation Procedure
2-25
Eq
uipment Insta
llation
2
0
This section describes how to strap the shorting plugs of the various jumpers. In the
Coral IPx Office system, some of the peripheral cards include jumpers that configure
the shared service functions. For a detailed card description, see
Chapter 9, Shared
Service Cards and Chapter 10, Peripheral Cards or the Peripheral and Shared Service
Cards Installation Manual . To set the configuration jumpers:
1. Connect the ESD wrist strap connector to the cage and put on the strap.
Synchronization Jumpers
Using the same synch. classification for multiple cards or cages can result in
system disruption. Verify that the synchronization jumpers are strapped as
described in
Chapter 10, Peripheral Cards .
Expansion Cage Identification Jumpers
Defining two expansion cages with the same cage number could lead to
system disruption. Verify that the cage numbering jumpers are strapped as
described in Chapter 6 of the relevant Installation Procedure and Hardware
Reference Manual.
2. In the IPx Office main unit, configure the peripheral card jumpers. See
Peripheral and Shared Service Cards Installation Manual .
3. For the IPx Office main unit, configure the ESIM card as described in
Figure 10-4 on page 10-23 .
4. For IPx Office expansion units, configure the ESIX card as described in
Figure 10-5 on page 10-24 .
5. For IPx 500X expansion cages, configure the jumpers as described in
Figure 2-18 and Figure 2-19 .
6. For IPx 800X expansion cages, configure the jumpers as described in
Figure 2-20 and Figure 2-21 .
7. For FlexiCom 200 CSLX expansion cabinets, configure the jumpers as
described in
Figure 2-22 and Figure 2-24 .
...................................................................................................
9 Strapping the Configuration Jumpers
Circuit cards contain static-sensitive circuitry and may be damaged or destroyed by
electro-static discharge (ESD). Always wear the static dissipating wrist strap connected
to the cage while handling cards. See Figure 2-14 on page 2-26 . Hold circuit cards by
their edges and avoid touching contact surfaces. Handle with care and do not drop.