Tadiran Telecom Coral IPx Office, Installation And Hardware Reference Manual, Page: 41 / 510

Coral IPx Office Installation Manual Introduction
1-13
About the Coral IP
x
O
ffice
1
0
The following tools are required in order to install and maintain the Coral IPx Office
system:
Required Tools:
„
4 mm (max.) flat blade screwdriver for installation and removal of the door
„
3/16", 1/4", and 5/16" straight-blade screwdrivers
„
#1 and #2 Phillips screwdrivers
„
Diagonal wire cutters
„
Long-nosed pliers
„
Electrician's pliers
„
Slip-joint pliers
„
Adjustable wrench
„
Wrench for ground cable hex nuts (3.2 mm x 7 mm)
„
Telephone cable cutters
„
Standard crimping tool
„
Telephone cable insulation strippers
„
16 ft (5m) measuring tape
„
Punch tool matching all telephone cable terminal blocks used at the installation
site
„
Digital Volt/Ohm/Amp meter
„
Telephone line test set capable of pulse and DTMF dialling
„
Static dissipating wrist strap
„
Portable (laptop) personal computer with a PCMCIA slot, capable of emulating
an asynchronous ASCII data terminal and approved by the manufacturer to run
the binary database save and restore utility, portable asynchronous ASCII data
terminal, or permanently installed on-site personal computer or ASCII data
terminal.
...................................................................................................
2 Recommended Tools