Tadiran Telecom Coral IPx 500, Installation Manual, Page: 386 / 544

8-10
Coral IPx 500 Installation Manual
MC
P-IPx Car
d
Main Pr
ocess
o
r Unit
8
0
Figure 8-3
illustrates the front panel of the MCP-IPx card. The front panel contains various
elements. The following table is a listing of the various functions and what they are for.
Table 8-1 MCP-IPx
Control Card Functions
3 Front Panel Features
Function What is it for?
Option DIP switches All switch should be set to OFF (right) so that the system will respond
after a power failure.
Status Display 7-segment display, used for alarms and diagnostic functions. A full list
of possible displays is provided later on in this chapter. See
page 8-20,
MCP-IPx Status Display Codes
.
Green LED Lit on to indicate normal system operation.
RST - CPU Reset
Push Button Forces the Coral system to restart.
Used to partially initialize the system (cause a warm restart procedure),
simulating the procedure that occurs automatically when power is
applied to the system.
Forcing initialization by pressing RST immediately disconnects all calls
in progress but does not default the database. However, resetting the
Main Processor while the database is being programmed, may corrupt
the database. If this happens, the database must be restored.
Pressing the RST button will cause a partial initialization.
All calls in progress will be terminated.
IMC8 Release
Button Used to release the IMC8 card.
IMC8 Flash Memory
card Used to save and restore the database as well as to store the Generic
feature software.
KB0 Data Terminal Port, DTE Interface, used to connect an RS232-E serial
cable, providing access to the PI or CoralVIEW CVA/CVD/CVT.
Default configuration:
9600 bps, No parity, 8 data bits, 1 stop bit, VT-100. See
page 8-13,
KB0 RS-232E Programming Port
.