Tadiran Telecom Coral IPx 500, Installation Manual, Page: 139 / 544

Initial Power-up Tests
3-19
Peri
pheral
Int
erf
ace Car
d
Init
ial
izati
on
3
0
Preparing for Initialization
After the software has been installed and initialized:
1. In the expansion cages, verify that the PS500 or PS19 power switch is in the OFF
position (turned downwards).
Before proceeding, verify that all power supply units within the expansion
cages are turned OFF. If the expansion cages are turned on before the main
cage, the peripheral cards within the expansion cages will not initialize
properly.
2. Check the position of shared service and peripheral interface cards that will be
inserted into the system card cage. Observe any order previously directed or any
established convention of the distributor. See
page 2-57, Peripheral Interface Card
Installation
and use the Card Placement Diagram, as described on:
„ page 2-60, Coral IPx 500 Main Cage 500M - Card Placement Diagram
„
page 2-61, Coral IPx 500 1st Expansion Cage 500X - Card Placement Diagram
„
page 2-62, Coral IPx 500 2nd Expansion Cage 500X - Card Placement Diagram
„
page 2-63, Coral IPx 500 1st Expansion Cage 800X - Card Placement Diagram
„ page 2-64, Coral IPx 500 2nd Expansion Cage 800X - Card Placement Diagram
3. Verify that all peripheral cards in the main cage and expansion cages protrude
from the cage by approximately 1 inch (2.5 cm).
4. Attach the Program Interface (PI) device cable to KB0 programming port
connector on the front side of the MCP-IPx.
Main Cage Initialization
1. Verify that the MCP-IPx control card has been initialized properly.
2. Insert the peripheral cards completely into their card slots. See
page 3-16, Rules for
Inserting a Coral Circuit Card
.
Insert the cards fully, one by one, from right to left (slot# 1-8) in adjacent card
slots, so that the installation corresponds with the uniform numbering plan.
2 System Initialization