Tadiran Telecom Aeonix T200M Series, Installation Manual

Page: 63 / 98

T200M Series Installation Manual - Aeonix Configuring the Phone via its Web Page 55
Overview
9
9
Configuring the Phone via its Web Page
................................................................................................................

Overview
This section describes how to configure and display the phone parameters through its
web page.
To configure a phone for the first time and define its network parameters, its web page
must be accessed from a computer connected to the LAN port of the phone.
After installing and setting up the
phone
for the first time, its web page can be
accessed by using its local or global IP address. Use the local address when
located within the LAN or the global address when located outside of the
LAN.
Contact the system administrator to determine whether you will be using a static or
dynamic IP address. It is recommended that T207M/NP, T208M/BL, T207M and
T208M telecommuters use dynamic addresses.
If a parameter is defined as dynamic, the T207M/NP, T208M/BL, T207M and
T208M
will attempt to contact a DHCP and/or DNS Server to retrieve the
information for that parameter. Therefore, if you define a mandatory address
as dynamic, ensure that the IP phone is on the same network as the relevant
DHCP and/or DNS Server.
This section describes the T207M/NP, T208M/BL, T207M and T208M configuration
via its web page:

Browsing to the Phone Web Page, page 56

Configuring the Phone Network Parameters, page 59

Configuring the Phone Parameters, page 63

Upgrading the Firmware Software, page 65

Configuring the MGCP Parameters, page 67