TAD DA1000, Owner'S Manual

Page: 17 / 128

17
English
Listening with suppressed DSD signal output
If the DSD signal output from the USB is excessively loud and sound is distorted, you can suppress the output level to make it
easier to listen. At the time of purchase, the DSD modulation rate is factory preset to
50 %
(high output level).

While holding the m ain unit’s front-panel MUTE button depressed, press the headphones volu m e (−) button.
Each time the button is pressed, the DSD modulation rate alternates between
50 %
(high output level) and
100 %
(low
output level).
ECO (power saving) mode
When this function is enabled, if no input signal is detected for 3 0 minutes, the unit automatically enters the standby mode.
U.S. model
:
ECO OFF (factory default setting)
European model : ECO ON (factory default setting)
1. With the unit in standby m ode, hold the m ain unit’s headphones volu m e (+) button depressed, then si m ultaneously press
the

power button. The ECO (power-saving) m ode will be enabled (unit will auto m atically enter standby m ode after 30
m inutes of no signal activity).
The display will then show the
[ ECO ON ]
message.
2. During standby m ode, hold the m ain unit’s headphones volu m e (−) button depressed, then si m ultaneously press the  power
button. The ECO (power-saving) m ode will be disabled (unit will not auto m atically enter standby m ode).
The display will then show the [ ECO OFF ] message.
ALL RESET
To return all settings to their factory defaults.
The default USB mode is AudioClass 1.0.
European model only
:
this setting sets the ECO (power saving) mode to ECO OFF .

With the unit in standby m ode, hold the MUTE button depressed, then si m ultaneously press the

power button.