TFM VT-222 Vortex Flowmeter User Manual
Three-line display mode
Line 1 displays the Instantaneous flow.
Line 2 displays the totalized flow.
Line 3 displays frequency, pressure,fluid temperature, density,
current, or percentage.
Notes:
►
When using the onboard pressure sensor, and the pressure signal has a fault condition, the
corresponding pressure value will be replaced with the set pressure value and it will flash.
►
When using the onboard temperature sensor, and the temperature signal has a fault condition, the
corresponding temperature value will be replaced with the set temperature value and it will flash as well.
►
When the flow mode is Sat_Steam(P), indicating it is in saturated steam pressure compensation, the
temperature value will display as " ", which indicates the measurement of the temperature sensor is not
enabled.
►
When the flow mode is Sat_Steam(T), indicating it is in saturated steam temperature compensation,
the pressure value will display as " ", which indicates the measurement of the pressure sensor is not
enabled.
Note: Long Press KEY-D to change the third line display variable(s) to one of the
following: Note this meter can accurately indicate the DENSITY!
Two-Line Display:
Bar Graph 0- 100% Full Scale
Line 1 displays the Instantaneous flow.
Line 2 displays the totalized flow.
TFM VT-222 Vortex Flowmeter Quick Manual Rev 10f page 7 of 30
