Online Audio Solutions, LLC – www.tacotunes.com
Mounting the Recurve in your Toyota:
Mounting your ReCurve EZ and amp(s) should be planned ahead. You will want to be sure
you can gain access to the knobs on your ReCurve EZQ and amp(s). In most cases we try to
install the amp(s) under the driver side seat and then the passenger side seat. We have
some example installations online for your particular Toyota. In the Toyota Tacoma and
Tundra we generally recommend mounting the ReCurve ON the seat if it folds down or
under the rear seat if it folds up. Cars & SUVs depend on your accessories and options.
Example third row seats or covers.
The ReCurve is NOT water resistant so be sure to mount it in a dry place . . keep in mind that
drinks are often spilled in vehicles. Also, try to keep it away from hot or confined areas that
trap heat.
NOTE: 5 channel amps (Speaker and subwoofer amp) have come a long way in recent years.
The days are two amps are becoming a thing of the past for most installations. Don’t get us
wrong, there are still plenty of multiple amp setups that make sense. Just depends on the
amount of power you are looking for
☺
☺
☺
☺
.
Speakers and subs, be sure to check out our vids on how to select speakers and subs for your
Toyota. For some Toyotas we have VERY detailed information on what fits along with
detailed installation videos. We are always offering give always to folks that provide
DETAILED installation pictures of Toyotas we have not yet documented a FULL install.
Installing and Routing the ReCurve Wiring System:
Routing the ReCurve wiring system from the head unit to your ReCurve EZQ is fairly simple.
Again, refer to installation videos and pictures of ideas. Just be sure the wires are not going
to interfere with any moving parts. i.e., brake, gas pedal, steering wheel, glove boxes etc . .
in most cases we recommend that you DO NOT run any of the ReCurve wires near the driver
side area. If necessary just be sure to route wiring away from all moving parts.
Wiring up the ReCurve EZQ:
Wiring up the EZQ is very simple. We have color coded every wire to insure you do not have
any problems. In addition, the ReCurve EZQ is clearly labeled to match each wire coming
from the stock head unit. You will strip away roughly ¼” of wiring and then insert into the
supplied wiring connectors. You can watch this video for more information on how to make
the connections:
