26/09/2023, 12:12
TNA-30x Operating Manual : Support & Learning Portal
https://tachyon-networks.freshdesk.com/support/solutions/articles/67000670226-tna-30x-operating-manual
2/10
Signal level LEDs
Signal LEDs are updated at a ~4 second interval.
Behavior
Meaning
All signal LEDs are off
The device is currently operating in AP mode, or the device is powered off.
The first LED is on & slowly blinking
The device is in station mode and is currently scanning.
All three LEDs are on & fast blinking
The device is currently updating its modem firmware. This only happens at
boot after a firmware upgrade.
The first LED is on and not blinking
The device is in station mode and currently connected to an AP with low
signal strength.
The first two LEDs are on, not blinking
The device is in station mode and currently connected to an AP with
medium signal strength.
All three LEDs are on, not blinking
The device is in station mode and currently connected to an AP with high
signal strength.
Ethernet port LEDs
2.5G ETH0
: The link light will turn on when a link is established, and the power light will turn on once the device is
supplied with power.
1G ETH1
:
The link light will turn on and blink when a link is established, and the PoE out light will turn on when PoE out is
enabled in software.
Powering your device
Input Power
i
Important Notes
The input power should be 48VDC and a minimum of .5A (24W) is recommended.
-48VDC is
not
currently supported.
TNA-30x devices can
not
be powered by active PoE (802.3at, etc).
The TNA-30x can be powered two ways, either via:
1. The Power over Ethernet (PoE) port or via
2. The DC input terminal.
