TabTimer™ helps keep medications on time™ |
www.TabTimer.com.au
| 1300 TAB TIMER (1300 822 846)
Pricing and specifications are correct at the time of publishing and may change without notice. Your health professional should be consulted prior to using any TabTimer
product to establish the suitability of a TabTimer product for use, administration or storage of any medications. In purchasing and continuing to use our products you have
agreed to and accept the Terms and Conditions shown on our website. Images are for illustration purposes only. Errors and omissions excluded.
TabTimer™, 'helps keep medications on time™' and the TabTimer™ logo are registered trademarks of TabTimer Pty Ltd © TabTimer Pty Ltd ABN: 99 137 415 948
SIMPLE
WATCH
INSTRUCTIONS
VIBRALITE
12
FUNCTIONS
OF
THE
WATCH
CALENDAR/TIME
ALARM
(up
to
12
per
day)
CHRONO
(STOPWATCH)
COUNTDOWN
TIMER
(TIMER
1
&
TIMER
2)
OPTIONS
(Vibration,
Sound,
Hourly
Chime,
Vibration/sound
when
buttons
are
pressed)
MODE
–
allows
you
to
move
around
the
different
functions
listed
above
and
is
also
used
in
programming
mode
to
move
around
the
options
within
each
function
SET/RST
–
allows
you
to
enter
into
programming
mode
and
exit
the
programming
mode
ST./STP
–
allows
you
to
change
the
settings
of
the
numbers/times
when
in
programming
mode
FACTORY
RESET
–
NOTE:
this
resets
the
watch
and
all
programming
and
settings
are
lost.
Holding
all
four
buttons
in
for
2
‐
3
seconds
turns
the
watch
off.
Release
and
hold
again
to
turn
the
watch
on.
TO SET THE TIME
1.
When you are on the normal date and time screen
– to enter programming mode, press and hold ‘SET/RST’ until T-ZONE 1 flashes.
2.
Press mode and the hour should flash
3.
To change the hour press ‘ST./STP’ until you reach the correct hour.
(Ensure that the ‘PM’ indicator is showing if you need the hour to be PM, or not showing if you need AM.
The indicator is in the first red square on the left hand side, under the day.)
4.
Press ‘MODE’ to move to the minutes
5.
To change the minutes press ‘ST./STP’ until you reach the correct minutes
6.
Press the ‘MODE’ to move to the seconds – if required, reset the seconds to ‘00’ by pressing ‘ST./STP’
7.
Press ‘MODE’ to move to the date and press ‘ST./STP’ to change the date
8.
Press ‘MODE’ to move to the month and press ‘ST./STP’ to change the month
9.
Press ‘MODE’ to move to the year and press ‘ST./STP’ to change the year
10.
Press ‘MODE’ to move to TIME format and press ‘ST./STP’ to alternate 12hr or 24hr
11.
Press ‘MODE’ to move to the DATE format and press ‘ST./STP’ to alternate between MM:DD
(Month:Date – American format) or DD:MM (Date:Month)
12.
Press ‘MODE’ and you will return to T-ZONE 1
13.
If you are happy with the settings you just programmed
- press ‘SET/RST’ to exit programming mode.
