T.I.P. Clean Jet 1000 Plus, Operating Instructions Manual, Page: 18 / 152

7
MALFUNCTION POSSIBLE CAUSE ELIMINATION
2. The motor is running,
but the pump is not
discharging any
liquid.
1.
2.
3.
The pump housing is not filled with liquid.
Air penetrates into the intake line.
Suction height and/or discharge height too
great.
1.
2.
a)
b)
c)
d)
3.
Fill the pump housing with liquid (please refer to
”Putting into operation” section).
Check to make sure that:
the connection points of the intake line are tight;
the inlet opening of the intake line including the
check valve (non-return valve) are immersed
into the liquids being discharged;
the check valve (non-return valve) with the filter
is tight and not jammed;
no siphons (i.e. permanently liquid-filled loops),
kinks, counter-slopes or narrow spots are
present along the intake lines.
Change the arrangement of the installation so
that the suction height and/or discharge height
will not exceed the max. value.
3. The pump stops after
a short time of
operation because
the thermal motor
protection feature
has triggered.
1.
2.
3.
4.
The electrical supply does not correspond to
the information given on the type plate.
Pump or intake line are blocked by solids.
Liquid is too viscous.
Temperature of liquid or environment is too
high.
1.
2.
3.
4.
Please use a device complying with GS
(German technical supervisory authority) to
check the voltage of the lines of the connection
cord (safety information to be observed!).
Remove possible congestion.
Pump may not be suitable for this liquid. If
feasible, the liquid should be thinned.
Make sure that the temperature of the liquid
being pumped and the environment do not
exceed the max. admissible values.
4. The pump does not
reach the desired
pressure.
1.
2.
Refer to section 2.2.
Worn pump wheel.
1.
2.
Refer to section 2.2.
Please contact the customer service
department.
10. Warranty
The present device was manufactured and inspected according to the latest methods. The seller
warrants for faultless material and workmanship in accordance with the legal regulations of the country
in which the device was purchased. The warranty period begins with the day of the purchase and is
subject to the provisions below:
Within the period of warranty, all defects which are to be attributable to defective materials or
manufacturing will be eliminated free of charge. Any complaints are to be reported immediately upon
their detection.
The warranty claim becomes void in the case of interventions undertaken by the purchaser or by third
parties. Damage resulting from improper handling or operation, incorrect setting-up or storage,
inappropriate connection or installation or Acts of God or other external influences are excluded from
warranty.
Parts being subject to wear and tear, such as the pump wheel (impeller) and mechanical shaft seals
are excluded from warranty.
All parts were manufactured using maximum care and high-quality materials and are designed for a
long lifecycle. It should be understood, however, that the wear and tear depends on the kind of use,
the intensity of use and the internals of maintenance. Complying with the installation and maintenance
information contained in the present operating instructions will therefore considerably contribute to a
long lifecycle of these wearing parts.
In case of complaints, we reserve the option of repairing or replacing the defective parts or replace the
entire device. Replaced parts will pass into our property.
Claims for liquidated damages are excluded unless they are caused by wilful acts or negligence on the
side of the manufacturer.
The warranty does not provide for any claims beyond those referred to above. The warranty claim has
to be evidenced by the purchaser in the form of the submission of the sales receipt. The present
warranty commitment is valid in the country in which the device was purchased.
15