T-Comfort Comfort Pro S, Mounting And Commissioning Manual

Page: 36 / 200

34
Installation Interface Cards
Installing Interface Cards
Each interface card is connected to the main board via two sockets. Comfort Pro S’s large slots have the
following characteristics:
■
There is no prescribed order for assignment. You can, for example, use an interface card in slot 2,
although slot 1 is not assigned.
■
Each slot is connected to a group of pressure terminals. The pressure terminals of a slot are given the
same colour to make them easier to identify.
■
The slots are not identical. Interface cards can therefore not be used in all and any slots. Please see the
overview under Position of the Interfaces starting on page 38 for details.
Installing an interface card
To install an interface card, please follow these steps:
1. Switch off the Comfort Pro S. Open the device (see Opening and Closing Comfort Pro S starting on
page 30).
label
handle here
handle here
1
2