16
Basic settings of the MP 2500 R
System Settings (System Configuration menu)
In the System Configuration menu general device settings are adjusted. This menu is described in detail in the following
chapter.
Calling up and operating
the menu
Briefly press the
button on the front panel or
button on the
remote control handset to call up the menu.
When you open the menu, the following Select points appear on the screen:
* only visible with installed gateway module.
Using the front-panel controls:
The SELECT knob is used to select any item within the menu system.
To change a selected menu item, press the SELECT knob to confirm your
choice, then adjust the value by rotating the knob.
After making the adjustment, press the SELECT knob again to adopt the
new setting.
You can interrupt the process at any time by touching the
button; in
this case any changes you have made are discarded.
Holding the SELECT knob pressed in takes you one level further down in the
menu system.
Touch the
button again to quit the menu.
Using the remote control handset:
Use the
/
buttons to select an item in the menu.
If you wish to change a selected menu item, first press the
button,
and then use the
/
buttons to alter it.
After making the change, press the
button again to accept the
new setting.
You can press the
button at any time to interrupt the process; the
change is then abandoned.
Press the
button again to leave the menu.
