T+A HV Series, User Manual

Page: 12 / 78

12
Front panel controls
All the important functions of the
SDV 3100 HV can be controlled using the buttons and rotary knobs on the front
panel. The large rotary knobs are used for navigation in lists and menus and to select the listening source. Functions
which are needed less frequently are controlled using a menu which is called up by pressing the
 -button.
All information relating to the machine’s state, the current track and the associated transmitting station are
displayed on the integral screen.

ON / OFF SWITCH

Touching the

-button briefly switches the device on and off.

The

-button remains dimly lit even in stand-by mode, to indicate that the
SDV 3100 HV is ready for use.
 Caution!
The  -button is not an isolation switch. Certain parts of the machine remain
connected to mains voltage even when the screen is switched off and dark. To
disconnect the device completely from mains power supply, the mains plugs
must be withdrawn from the wall socket.
If you know you will not be using the machine for a long period, we recommend
that you disconnect it from the mains.

VOLUME CONTROL / SOURCE SELECTION
VOLUME / SOURCE This rotary knob is used to set your preferred volume in accurate 1 dB
increments. The value currently set is displayed on the screen.
The desired listening source is selected by turning this rotary knob; your
chosen source then appears on the screen. After a short delay the machine
switches to the appropriate source.

The main function of this knob can be changed if necessary. In this case, the
button must be pressed briefly before the volume can be changed (see
chapter
'Basic settings of the SDV 3100 HV' ).
 A long press on this knob switches to balance adjustment: turning the knob
to left or right then alters the balance in the corresponding direction. Press
the knob again long to conclude the adjustment and save the setting.