33
Starting playback
Press the
button on the remote control handset or the machine’s front
panel to start playback.
Stopping playback
Pressing the
button halts playback.
Skipping tracks
A brief press on the
/
buttons during playback causes the
device to jump to the next or previous piece of music within the current playlist.
Playback of directories
In addition to the facility to play back
individual folder content, it is also
possible
to
play
back
entire
directories. This is accomplished by
selecting the folder of the directory to
be played, then pressing the
button to start playback. Playback
commences with the first entry in the
list of content to be played. If an entry
in the list should contain a folder with
additional sub-folders, the content of
the lowest folder is always played first.
This is followed by the content of the
next higher folder level, etc. (see
diagram right).
Search function
When you are navigating through lists you can call up the
MP 2500 R
`s
letter
search function at any time by briefly pressing the blue
button. The
screen now displays the message “Search”. While this is on the screen, enter
up to eight letters or numerals using the remote control handset; the letters
assigned to the numeric buttons are printed below the buttons. To obtain a
particular letter, press the appropriate button repeatedly until the correct letter
appears on the screen. Before entering the next character you have to wait until
the cursor is displayed again. Press the
button to erase any letter.
After pressing the
button or after a brief delay with no further input the
MP 2500 R
moves to the first entry in the list which starts with the characters
you entered.
If the text searched for is not found the best matching result will be shown. You
can abort the search using the
-button.
The function searches only the current folder. Eventually existing subfolders are
ignored.
Front panel display
The
MP 2500 R
provides different screen displays for the Streaming Client.
A long press on the
–button on the remote control handset is used to
switch between the display modes.
Large-format display:
Enlarged display of the most important information, clearly legible even from
a distance
Detail display:
Small-text display showing a large number of additional information points,
e.g. bit rate etc.
