Chapter 6. Configuration via Telnet
def portviewport
<Port Number>
4000
Set the socket number of the PC with Portview
installed.
def snmp
[Enable / Disable]
Disable
Enable or disable SNMP(Simple Network Management
Protocol) support.
▪
MIB-II (RFC 1213): System, Interface, IP, ICMP, TCP,
UDP
▪
MIB-I (RFC 1317): Serial Interface
def telnet
[Enable / Disable]
Enable
Enable or disable Telnet service.
If disabled, you cannot connect to Eddy via Telnet.
def ftp
[Enable / Disable]
Enable
Enable or disable FTP service.
If disabled, you cannot connect to Eddy via FTP.
Def ddns
[IP Address]
203.32.117.1
If you set DDNS server IP , DDNS service will be
enable. But you set “0.0.0.0” ,this service will
disable.
Def ddnsuser
[username]
eddy
You can access DDNS server with this ID.
Def ddnspass
[password]
99999999
You can access DDNS server with this password.
def web
[Enable / Disable] Enable
Enable or disable Web service.
If disabled, you cannot connect to Eddy via Web.
def target_agent
[Enable / Disable]
Disable
Enable or disable remote debugging function used by
Eddy development environment, LemonIDE®.
For more information, please refer to LemonIDE user
manual in the SDK CD included in Eddy-DK package.
def name
<Eddy name>
Name of the
module
Set the name of Eddy module. (Max 32 bytes)
6.4
Serial Commands
You can set the communication and operation environment for the serial port. Chapter 5 describes
each option in detail. Only a summary of each option is presented here.
Table
6
-
3
Serial commands
Commands
Default
Descriptions
def port 1 protocol
[disable / com /
tcp_server / tcp_client /
tcp_broadcast /
tcp_multiplex /
udp_server / udp_client]
com
Select the operation protocol, which the serial port
would use.
6-3
