Do not dry out the air filter under direct sunshine or with fire.
For the one-way cassette type , the air filter should be installed
before the unit body installation.
1
2
2. Dismantle the air filter.
3. Clean the air filter
4. Re-install the air filter.
5. Install and close the inlet grille in the reverse orders of step
1 and 2 and connect the control box cables to the corre
sponding terminators of the main body.
CAUTION
The air filter can prevent the dust or other particulate from
going inside .In case of blockage of the filter , the working
efficiency of the air conditioner may greatly decrease .
Therefore , the filter must be cleaned twice a month during
prolonged use.
Clean the air filter with vacuum cleaner or water.
a.The inlet side should face up when using vacuum
cleaner. (Refer to
Fig.5-13
)
b.The inlet side should face down when using clean water.
(Refer to
Fig.5-14
)
If the dust accumulation is too heavy, please use soft bursh and
natural detergent to clean it and dry in the cool place.
Fig.5-15
Fig.5-16
12
owner’s manual
Inlet grille
According to the figure shown in the position and
direction of arrow, press the filter and take it down. In the
same way,take down the filter on the other side,and put it
back after cleaning.
■
Air Out Louver
(Adjustable)
Air Filter
(Filter the dust in the intake air)
Air Intake
(Intake room air here)
Inlet grille
Fig.5-11
Fig.5-12
Fig.5-13
Fig.5-14
When the power switch is connected, some energy will be
consumed, even if the unit is not in operation. So please
disconnect the power to save the energy.
A degree of dirt will be accumulated due to certain performance
after several seasons of operation. So special maintenance is
advised.
Take out of the batteries from the remove controller.
NOTE
Maintenance before a long stop period
(eg. at the end of the season)
Let the indoor units run in fan only operation for about half a
day in order to dry the interior of the units.
Clean air filters and casings of indoor units.
Refer to “Cleaning the air filter" for details on how to proceed
and make sure to install cleaned air filters back in the same
position.
Turn off the unit with the “ON/OFF” button on the remove
controlller,then disconnect the power.
