SystemAir Sense SNX, Installation,Operation And Maintenance Instruction, Page: 9 / 28

9
5.3 To install the product
For the installation on the wall measure the location and
size of the holes carefully:
• two wall openings for duct connections
• four drill holes (six holes for SNX 1000) at the ceiling for
unit installation (drill points marked in red).
Position of drill holes in the ceiling
Position of wall openings
First drill the holes into the wall for connection. After that,
drill the holes to the ceiling.
Caution
Dimension Bmin only corresponds to
installation where unit leans on the
back wall.
Note
M8 threaded rods with a distance of 500 mm is
availible as accessory.
D
A
L
1,min
R
1,min
H
1,min
D
L
2,min
R
2,min
B
min
E
E/2
E/2
F
Le
ft w
al
l
Righ
t w
al
l
Outer wall
SNX 700 SNX 1000
A mm 1616 1800
B
min
mm 152 152
D mm 315 315
E mm 846 996
F mm 2080 2350
H
1,min
mm 225 285
L
1,min
mm 732 775
R
1,min
mm 332 375
L
2,min
mm 475 475
R
2,min
mm 75 75
1. Unpack the product and place the product in the
correct installation position.
2. After the holes are drilled into the ceiling, install
threaded rods in length required for the specific room.
3. Gently lift the units from bellow. Use protective
clothing, so the unit’s surface does not get damaged.
4. Set the unit to required height with threaded rods
inside the brackets.
5. Install the washer and nut to bracket from bellow.
Note
Opening the unit before installation is not required.