System Equine TRC-6, Assembly Instructions Manual

Page: 5 / 8

STEP 5
ATTACHING THE TINE HEIGHT ADJUSTMENT BAR
See STEP 5 photo before proceeding
1. Locate the tine height adjustment bar and fasten to the center support
of the tine bar assembly using the 1/2” x 1 1/2” bolt & lock nut STEP 5
photo.
2. Lift and attach the other end to the center hole of the tine height adjust-
ment bracket attached to the under side of the A-frame using one of the
5/8” x 4 1/2” hitch pins and secure in place with the cotter pin.
STEP 6
FINALIZING BLADE POSITION
See STEP 6 photo before proceeding
1. Lift the blade from either side until the center blade pitch angle adjust-
ment hole is lined up with the hole in the blade post. Then secure in
position with the remaining 5/8” x 4 1/2” hitch pin.
ATTACHING THE TRACK AND RING CONDITIONER USING THE 3 POINT
HITCH ASSEMBLY
STEP 6
ATTACHING TO THE TRACTOR
1. Backup your tractor with a 3 point hitch to the Track Conditioner. Make
sure the area is clear of people and animals.
2. Position the tractor so the lift arms line up with the lift pins on the con-
ditioner.
3. Slide the lift arms over the lift pins and put on the clip pins.
4. Attach the top link supplied with your tractor to top of the three point
hitch with the hitch pin supplied.
5. Adjust to the top link until the "A" Frame of the conditioner is level.
See operation instructions on last page for proper use of your Track and
Ring Conditioner.
TINE HEIGHT ADJUSTMENT
A-frame
L-shaped
draw pin
Center sup-
port tine bar
assembly
Tine height
adjustment
bar
Tine height adjustment
bracket
STEP 5
BLADE POSITION
Blade pitch angle
adjustment holes
5/8” x 4 1/2”
hitch pin
3/4” x 5” bolt
and nut
1/4” angle iron
for strength
and durability
Blade
Blade angle
adjustment pin
Blade post
STEP 6