Synway Information Engineering Co., Ltd
SMG-D Series Analog Gateway User Manual (Version 2.0.0)
Page 43
After configuration, click
Save
to save the settings into the gateway, click
Reset
to restore the
configurations, or click
Cancel
to cancel the settings.
Check All
means to select all available
ports on the current page;
Inverse
means to uncheck the selected items and check the
unselected.
Check All FXO Ports
means to select all available FXO ports on the current page;
Check All FXS Ports
means to select all available FXS ports on the current page.
Click
Modify
at the end of the list in
Port Group Settings Interface
to modify the properties of a
port group. The configuration items on this interface are the same as those on the
Add New Port
Group
interface.
To delete a port group, check the checkbox before the corresponding index in Figure 3-11 and
click the „
Delete
‟ button.
Check All
means to select all available items on the current page;
Uncheck All
means to cancel all selections on the current page;
Inverse
means to uncheck the
selected items and check the unselected. To clear all port groups at a time, click the
Clear All
button in Figure 3-11.
3.7.6 Advanced FXO Settings
The table below explains the configuration items on the Advanced FXO Settings interface.
Item
Description
Mailbox Account,
Password
Sets the account and password of the mailbox.
Outgoing (SMTP),
Port
Sets the server address and port for Email sending.
SSL
Sets whether to encrypt the sending/receiving mails via SSL.
Recipient
Sets the address of the recipient.
Subject
Sets the mail subject.
Content
Sets the mail content.
FXO Off-line Alarm
After selecting the ports, the gateway will send the alarm email when the selected
ports are off-line.
Blacklist of FXO Out
Calls
Fill in the rule to match FXO outbound blacklisted number. All the numbers
matching this rule will be prohibited by the gateway to call out from the FXO port.
Sensitive Number
Call Out Limit
Sets whether to forbid sensitive numbers (110, 119, 120, 122) to call out from the
FXO port. By default it is checked.
International Call
When this function is enabled, the numbers starting with 00 can be called out from
the FXO port. It is disabled by default.
Blacklist of FXO
Incoming
Sets the blacklist of the FXO incoming calls.
Processing Mode
Sets the processing mode for the blacklist, including two options: Hang up after
pick-up and Hang up after ringing. The default value is
Hang up after pick-up
.
Hang-up Delay
Sets the delay to hang up the call after the pick-up.
After configuration, click
Save
to save the settings into the gateway or click
Reset
to reset the
settings.
3.8 Route Settings
Route Settings is used to specify the routing rules for calls on two directions: IP
Tel and Tel
IP.
