机床产品
/Machine Tool Products
–
610-E5/610-H5 5-Axis Wood Operation Manual
How to Operate 21 Series Controller
–
m.
n.
o.
p.
q.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
coordinate?], press [Yes] and the system will set the X, Y axis auxiliary coordinate value into the
assigned workpiece coordinate.
It's able to return to the "Set Workpiece Coordinate" screen with left arrow key.
Move cursor to the X coordinate of the workpiece coordinate requires setting and press "Apply Aux.
Coord,".
System confirmation window will show up [Apply Aux. Coord,?], press [Yes] and the system will set
the X coordinate of "Aux. Coord." to the workpiece coordinate which the cursor is at.
Move cursor to the Y coordinate of the workpiece coordinate requires setting and press "Apply Aux.
Coord.".
System Confirmation window will show up [Apply Aux. Coord.?], press [Yes] and the system will set
the Y coordinate of "Aux. Coord," to the workpiece coordinate which the cursor is at.
3.3.3 Tool Prepare
Tool Set
Purpose
We can set the length and the diameter geometry and wear
Operation condition
Can be used at Manual or Auto mode
Wear value increment upper limit is 1.0, warning will appear if exceed 1.0.
Operation method
Use direction key
【
↑
】【
↓
】【
←
】【
→
】
move the cursor.
Use
【
PageUp
】【
PageDown
】
switch the page.
Key in method: Absolute, Increment, Measure method.
Absolute: for radius and length compensate.
Increment: for radius wear and length wear.
Radius comp radius wear = real G41/G42 compensate.
Length complength wear = real G43/G44 compensate.
Manual Measurement of Tool Length
Purpose
Describe how to use manual measurement to set tool length and work piece coordinate in order to
set the machining tool.
Function
We usually set the tool length and offset in the External Shift if we only use one tool in this machine.
If we have more than one tool, we need to set every tool length we can use relative length or absolute
length.
Operation condition
Manual mode.
Manual Operation method
-Relative method.
Use manual function moving the
reference tool
to the Z-coordinate code 0 position of the workpiece
(Ex. surface), set the value at G54.
Clean all the relative coordinate value.
Install the measured tool, move the tool to the same position as before (reference surface).
The tool length is the different between measured tool and reference tool.
Key in this number to the corresponding tool No.
If tool break during machining and replace a new tool, we need to change to a new tool. If the Z-cord
0 position already disappear, we can use the standard tool to touch anywhere of the machine and
then use new tool to touch the same position. The relative cord. is tool length.