When you first start up your system, go immediately to the Setup Utility to
configure the floppy diskette drives that you have installed.
Installing Add-on Cards
The slots in this mainboard are designed to hold expansion cards and connect
them to the system bus. Expansion slots are a means of adding or enhancing
the mainboard’s features and capabilities. With these efficient facilities, you
can increase the mainboard’s capabilities by adding hardware which performs
tasks that are not part of the basic system.
PCI Slots
PCI slots are used to install expansion cards that have the 32-bit
PCI interface.
AGP Slot
The AGP slot is use to install graphics adapter that supports the
1.5V 8x AGP card which is
also backward compatible with 4x AGP
card. The slot is keyed to support only the latest 1.5-volt AGP
cards.
Note:
The above layout is for reference only. The AGP slot
may be different from your mainboard. Please refer to
actual shipment.
CNR Slot
This slot is used to insert CNR cards with Modem and Audio
functionality.
Note:
Before installing an add-on card, check the documentation for the card
carefully. If the card is not Plug and Play, you may have to manually
configure the card before installation.
19
