Section I
Warnings
006-0006452 MPC-1500 Operator Guide
Rev P
5 of 48
03/03/2021 www.synqor.com
• For the DC OUTPUT cable and connector (if present):
▪ The rated DC output voltage of the MPC is below the level considered hazardous.
▪ The DC output terminals of the MPC are isolated from the AC input and AC outputs with
reinforced safety insulation.
▪ However, never assume the terminals of the DC output connector or the wires of the DC
output cable are safe to contact, even if the MPC appears to be off.
Hazardous Energies
The INPUT AND OUTPUT POWER connectors and cables of the SynQor MPC may be the source
of high levels of energy. Do not inappropriately make electrical contact between any terminal of
a connector and another, or between any wire of a cable and another, or between any terminal
or wire and the MPC’s chassis or ground. DAMAGING ELECTRICAL ARCS may result. Care should
be taken to avoid accidental electrical contacts of this sort.
Protection from the Environment
The SynQor MPC is a ruggedly built product having its electronics contained in sealed chambers.
It is capable of withstanding harsh levels of mechanical acceleration, shock and vibration,
temperature and pressure variations, and exposure to water, salt, sand and dust within the levels
specified in the data sheet. THESE LEVELS SHOULD NOT BE EXCEEDED.
Do not obstruct the air intake in the front of the MPC or the fan exhausts in the rear panel of the
MPC while the MPC is operating.
No User Serviceable Parts
The SynQor MPC has no user serviceable parts inside of it. DO NOT REMOVE the cover of the
MPC or any of its connectors. Only factory trained personnel should perform repairs.
