006-0006205
UPS-1500 Series
Rev ZC
7 of 60
05/28/2019
Section II
General Product Information
Product Description
The SynQor UPS-1500 Series is an advanced technology military-grade uninterruptible power
supply (UPS) that uses lithium polymer batteries and highly efficient power electronic circuitry
to achieve a high power level and battery run-time in a low-profile, low-weight, rack-mountable
package. It provides voltage and frequency conditioning, electrical isolation, and power flow
smoothing between the power inputs and its power outputs. It provides battery backed-up
power when other power sources are not present.
A communication/control port is available to permit monitoring and control by a host computer
system. Front panel LEDs and an audible alarm provide information on the status of the UPS and
the battery pack.
The UPS-1500 Series products can draw power from an AC input having a wide range of voltage
and frequency levels, or from an optional 28 V nominal DC input. The AC input has priority over
the DC input. The UPS provides up to 1500 VA and 1250 W of AC output power at 115 Vac. The
pure sine wave AC output voltage can drive any non-linear load with a crest factor up to 2.5, and
any load power factor from 0.0 to 1.0. There are two optional DC outputs at various voltage and
power levels available. The total AC plus DC output power is limited to 1250 W.
The electronic circuitry within the UPS-1500 Series products is designed, qualified and screened
according to SynQor’s MIL-COTS Standards. It complies with the requirements of MIL-STD-704F,
MIL-STD-1399-300B, MIL-STD-1275D and MIL-STD-461F, as well as IEC-EN61000 specifications
for world-wide commercial utility applications.
The UPS-1500 Series products are designed and manufactured to withstand the harsh environments
and use encountered in military applications. The electronic circuitry and battery are contained in
a sealed chamber constructed from a die-cast aluminum chassis that is weather-proof and shock-
proof. Redundant, water-proof fans on the rear panel draw cooling air over the heat-sink fins below
the sealed chamber. Military-grade circular connectors are used, and optional attached connector
covers are available for when the cables are not attached. The UPS-1500 Series products comply
with a wide range of testing according to MIL-STD-810G.
The UPS-1500 Series has two product formats: 1) a 1U high unit that has a standard battery pack
that provides >10 minutes of full-power run-time, and 2) a 2U high unit that has an extended
battery pack that provides >24 minutes of full-power run-time. The former weighs approximately
32 lbs. and the latter 50 lbs.
The SynQor UPS-1500 Series products are designed and manufactured in the U.S.A.
