SynOptics SYNBIOSIS aCOLyte3, User Manual, Page: 61 / 110

The Results tab
To display the results controls:
Press the Results tab:
You can set a default selection of results in the Batch Designer, but you can also make a
different selection at any time in Measurement mode as required.
Results with a selected check box will be included in the Results table; unselected results will
not be included. The order of the results in the list is the order they will appear in the Results
table.
To change whether a result will be included in the Results table:
1. Click on the result to select it.
2. Click on the result again to select/deselect the check box.
3. To carry out the change when working in Measurement mode, press:
To move a result up or down the list to change the order of results in the Results table:
1. Click on the result to select it.
2. To move the result up the list, press
To move the result down the list, press
3. To carry out the change when working in Measurement mode, press:
aCOLyte3 User Manual 55