Synology SA3600, Hardware Installation Manual

Page: 20 / 31

20
Chapter 2: Hardware Setup
LED Indicator Table
LED Indicator Color Status Description
Power
Blue
Static Powered on
Blinking Booting up / Shutting down
Off Powered off
STATUS
Green Static Volume normal
Orange Blinking
Volume degraded / Volume crashed
Volume not created
DSM not installed
Off HDD hibernation
ALERT
Orange Blinking Fan failure / Over temperature
Off System normal
Drive Status Indicator
(on tray)
Green
Static Drive ready and idle
Blinking Accessing drive
Red Static Drive error / Port disabled
1
Off No internal drive
PSU Indicator
Green Static Power supply unit normal
Off Power supply unit off
Rear 1GbE LAN
(on left side of jack)
Green
Static Network connected
Blinking Network active
Off No network
Rear 1GbE LAN
(on right side of jack)
Green
Static
1 Gbps connected
Orange 100 Mbps connected
Off 10 Mbps connected / No network
Rear 10GbE LAN
(on left side of jack)
Green
Static Network connected
Blinking Network active
Off No network
Rear 10GbE LAN
(on right side of jack)
Green
Static
10 Gbps connected
Orange 1 Gbps connected
Off No network
Note: Model specifications are subject to change without notice. Please refer to
www.synology.com
for the latest information.
1
Please try to restart your Synology NAS or re-insert the drive(s), and then run the HDD/SSD manufacturer's diagnostic tool to check the health status of the
drive(s). If you can log into DSM, please run the built-in S.M.A.R.T. test to scan the drive(s). If the problem remains unresolved, please contact Synology
Technical Support for help.