11
Chapter 2: Hardware Setup
Install Memory Modules
You must install genuine Synology memory module(s) to ensure system compatibility and reliability. Be sure to
follow the configurations below for the suggested installation sequence of different memory capacities, otherwise
the system may not boot successfully, or system performance and stability may suffer.
A0
A1
B0
B1
Total Memory
16GB
-
-
-
16GB
32GB
-
-
-
32GB
16GB
-
16GB
-
32GB
16GB
16GB
16GB
-
48GB
16GB
16GB
16GB
16GB
64GB
32GB
-
32GB
-
64GB
32GB
32GB
32GB
-
96GB
32GB
32GB
32GB
32GB
128GB
Note:
It is required to use identical memory modules of the same capacity and frequency.
Follow the steps below to install, check, or remove a memory module on your SA3600.
To install the RAM module:
1
Shut down your SA3600. Disconnect all cables connected to your SA3600 to prevent any possible damage.
2
Remove the screw on the back of SA3600. Pull the rear top cover, and put it aside.
Note:
When you remove the rear top cover, sensitive internal components are exposed. Avoid touching anything
other than the memory assembly when you remove or add memory.
