Synology RS2821RP+, Hardware Installation Manual

Page: 12 / 32

Tools and Parts for Drive Installation
Please prepare below tools and parts before setting up your Synology NAS:
• A screwdriver
• At least one 3.5" or 2.5" SATA drive (please visit
Synology Products Compatibility List
for compatible drive
models)
Warning: If you install a drive that contains data, the system will format the drive and erase all existing data.
Please back up any important data before installation.
• Rail mounting kit (please see the Optional Accessories section to find out the suitable rail kit for cabinet
installation)
Warning: We suggest mounting your Synology NAS on a cabinet before installing any drives since the heavy
weight will increase the installation difficulty.
Install Drives
Please follow the steps below for drive installation:
1 Open the drive tray.
a
b
R
a Press the small button located on the left side of the drive tray handle. The drive tray handle pops out.
b Pull the drive tray out by its handle as shown above.
2 Install drives:
•
For 3.5" drives: Place the drive in the drive tray. Turn the tray upside down and tighten screws into the four
spots indicated below to secure the drive in place.
Hardware Setup
12
2
Chapter