Synel SY-760, User Manual

Page: 35 / 106

-
33
Global threshold
Specify the global threshold level as: '0' -Very Low, '1' - Low, '2' - Medium, '3' - High, '4' - Very High.
Enrollment mode
Set the enroll mode as follows:
0 – One Time - supported by all units
1 – Two Times FPU-S units only
A – Two Templates FPU-S units only
Where:
One time – Enrolls a scanned fingerprint to a fingerprint template.
Two times – Scans the fingerprint twice. The two images are compared to each other and verified. If the fingerprint images do not match
the user is rejected. If they match the better quality fingerprint is enrolled in the template.
Two templates – Scans the user finger twice and saves the each fingerprint scan as a template. The user has two templates stored. Then,
each time the user is verified, the module can decide whether to replace the existing template with a new one. This update reflects the
dynamic changes in the skin of the user's finger.
Exit
Back to WIFI diagram
After setting the previous parameters you get the following options:
Save Param - Saves your specified setting.
Exit -
Exits Technician mode.
Set - Returns to the beginning of the Technician mode parameters enabling you to change or reset parameters.
Additional - Displays additional parameters according to the parameters selected before, such as Network parameters if TCP or UDP, or Network mode
of Server or Client.
On exiting Technician mode, all of the settings are saved into the terminals Flash protected memory. In case of memory crash the terminal reloads the
settings from the flash memory (does not revert to the factory default), which enables quick communication after formatting the memory.
Once the technician mode settings are entered into the system and the user exits the Technician menu, the settings are automatically saved to the termi-
nals Flash memory. If a “Mem Crash” occurs, the terminal loads the parameters saved in the Flash memory.
One time Two times Two templates
Scan
1 2 2
Save template
1 1 2
Modification
- - +