SynCardia Companion 2 Driver System, Operator'S Manual

Page: 103 / 134

SynCardia Systems, LLC
Companion 2 Driver System Operator Manual
Page 103 of 132
Chapter 17. Switching from Companion 2 Driver System to
CSS Console
NOTE: The procedure described below to switch drivers is the same for both the
50cc TAH-t and 70cc TAH-t.
17.1. Materials
Prior to switching from the Companion 2 Driver System to the CSS
Console, assemble the following materials:
•
One set of CSS Console Drivelines
•
CSS Console with power ON
•
CPC connectors (male and female)
•
Male 3/8 connector, part number: 170088-003
•
Female 3/8 connector, part number: 170087-003
•
Locking ties
•
Scissors
Note: The female CPC connector is always inserted into the blue
marked Driveline. The male CPC connector is always inserted
into the
red marked Driveline.
17.2. Preparation for of the CSS Console and Drivelines for Driver
Exchange
17.2.1. Prior to switching to the CSS Console, the Console should be
prepared in the following manner:
•
Ensure that the drive parameters are set appropriately for the
patient.
•
Turn on the CSS Console and alarm panel.
•
Attach the CPC connector to the CSS Console Drivelines
(follow instructions below) and ensure that air is pulsing from
the free ends of the Driveline.
17.2.2. When switching from the Companion 2 Driver System to the CSS
Console, change the Driveline connections that connect to the
CSS Console:
•
Remove the hose barb connectors from the CSS Drivelines.
•
Insert a 3/8” female CPC connector (P/N 170087-003) into the
blue marked Driveline. This is the connector that has the lock
on it.
•
Insert a 3/8” male CPC connector (P/N 170088-003) into the
red marked Driveline. This is the connector that does not have
the lock on it.