Thank you for purchasing SyncAV™ SSAV-EX1PO-V2. For best
results and your safety, please read the instructions and keep the
manual for future reference.
Important!
1. Do not connect or disconnect any cables while powered
2. Do not mix up the transmitter unit (TX) with the receiver unit
(RX), and the IR blaster extension cable with the IR receiver
extension cable
3. Use supplied DC 5V/2A adapter only. Using wrong power
adapter can be a safety hazard, may cause damage to the
equipment and will void warranty
Introduction
SyncAV™ SSAV-EX1PO-V2 HDMI extender transmits various
resolution HDMI video over a single CAT6/6A/7 cable with zero
latency and supports IR passback allowing user to control the
source device with IR remote from the receiver site.
It supports POE to power the receiver (Connect power supply to
the Transmitter unit only, each unit will power up, as the Receiver
unit is powered by the Transmitter unit through network cable).
Features
1. Plug-and-play operation, no installation required.
2. Transmits uncompressed full HD signal with zero latency
3. Works with most HDMI devices
4. Supports IR passback
5. Receiver can be powered by the transmitter through PoE
What’s in the Box
Setting up the system
Connect all the components as per picture below. Make sure
all the cables are plugged in BEFORE powering up the system.
Plug the power supply to Transmitter unit only. Place the IR
blaster as close as possible to the device you want to control
with your remote. Wait ‘till the connection is established (LINK
LED on the receiver unit turns solid).
[NOTE]
It is recommended to use a length
range within 15~50m network and
with good quality copper wire
➀
IR signal output to connect with
blaster extension cable
➄
DC5V power input
➁
RJ45 signal output
➅
HDMI signal output
➂
HDMI signal indicator led: it lights
on all the time when HDMI signal
input, flashes when no signal input
➆
EDID switch
➃
Reset Button
➇
HDMI signal input
➀
DC5V Optional power input
➃
LENGTH: for adjusting to the
length of network cable
➁
HDMI signal output
➄
RJ45 signal input
➂
IR signal input to connect
with IR receiver extension
cable
➅
RJ45 indicator led: it lights on
all the time when HDMI signal
transmission, flashes when no
signal transmission
Panel Description
1. Transmitter unit (TX)
2. Receiver unit (RX)
1 x
Transmitter unit (TX)
1 x
Receiver unit (RX)
1 x
IR blaster
extension cable
1 x
IR receiver
extension cable
1 x
DC adapter
User manual
Transmitter (TX)
Cat6
Cable
HDMI in from
Media Source
HDMI out to Display
Receiver (RX)
IR
blaster
IR receiver
HDMI out to Display